Have you ever needed to capture a logic signal to check that your Arduino or Raspberry Pi project is doing what it’s supposed to be doing, but you don’t have an oscilloscope? Or maybe you do have a ‘scope but it doesn’t have a storage mode, so the signal goes past far too quickly to see.
No need to shell out loads of money on an expensive logic analyser, when you have one with virtually unlimited storage capability right in your PC! You can use the sound card to capture logic signals as they pass through the bus, and then investigate the signal timing at your leisure.
The only problem is logic signals are generally +5V or +3.3V, whilst the line-in on your soundcard is designed to capture only voltages between plus and minus 2V at most. We can easily get around that by making a voltage divider out of a couple of resistors. I used an 82K and an 18K resistor giving me a 1/5 voltage reduction. That makes my +5V logic signal just 0.9V which is well within the range of the soundcard input. The resistor values don’t matter too much, so long as they have a ratio that brings your logic level down to something appropriate for the soundcard. Although it’s best to try to keep the total impedance as high as possible to prevent the connection interfering with your circuit.
First, get an old stereo cable with a 3.5mm jack plug. Cut off one end and strip the insulation to reveal the shield braiding and the two conductors.
Unbraid the shielding, and solder on your 18K resistor, and a length of wire that will form the “ground” connection for your logic probe. I’ve used two since I’m making up both channels. Use the left and right stereo inputs to make a two-channel logic analyser!
Put a bit of heat shrink over the joint to isolate the connection. Next, solder your 82K resistor onto the other side of the 18K resistor, and attach the left and right signal cables to the centre point of the voltage divider.
Attach your signal probe wires to the far side of the 82K resistor. Again, isolate the connections with some heat shrink.
Finally, put some more heat shrink over the whole thing to secure it all together. Nice tidy job!
Now you’re ready to feed it some signals and capture them. I used Audacity under Linux which is a free, open source, cross-platform application for recording and editing sounds. It’s perfect for this task.
Here we are capturing two square waves at 192kHz sampling frequency. You’ll notice that the square waves are not very square, especially at lower frequencies. This is because the soundcard has a high-pass filter and tries to reject DC offsets. As soon as the square-wave pulses to a positive or negative level, the soundcard starts to pull the signal back to zero and the signal “droops”. That’s not too much of a problem, since we’re only aiming to look at the pulses and be able to measure the timing and synchronisation with other logic channels. For this, it’s perfect for the job!
Don’t make the mistake of thinking you can use this as a replacement for a proper multi-meter or an oscilloscope. If you decide to try to measure the frequency of your mains electricity you will destroy your soundcard and probably your whole PC.
But for the purpose of capturing logic signals - it’s perfect!